AVSL 952.821 C25V - Manual

C25V
Compact Background Speakers
Item ref: 952.820UK, 952.821UK
User Manual
Introduction
Thank you for choosing the C25V series indoor speakers. These speakers have been designed to offer high quality sound for 100V line
or low impedance installations. Please read and follow the instructions in this manual to achieve the best results and avoid damage
through misuse.
Caution
C25V speakers are intended for indoor use. Avoid moist or dusty environments. Avoid excess heat and exposure to direct sunlight.
For 100V installation, take proper care to insulate any contacts within reach of users.
Installation
Each C25V speaker is supplied with an adjustable wall-mounting bracket which slots into the rear of the enclosure. When fixing to a
wall or ceiling, use the bracket to mark out the fixing points and use appropriate fixings for the substrate that the speaker will be
attached to, ensuring that the fixing is strong enough to bear the weight load.
Connection
C25V speakers are connected via 2 sets of spring terminals at the rear of the enclosure. For 100V operation, use double insulated
cable connected to the lower terminals marked “6W”. This will draw a maximum 6Wrms from the 100V amplifier. With the amplifier
switched off, strip the speaker wire ends and connect 100V or “+” wire to the red terminal and connect Common or “-”
to the black terminal. Ensure that the sum of the wattages of all the speakers attached to the amplifier does not exceed
the recommended output of the amplifier.
When used with a standard (non-100V) amplifier, connect to the “8Ω” terminals and refer to the amplifier
manufacturer’s manual to ensure that total speaker impedance (Ω) is not less than recommended for the amplifier.
Refer to the amplifier manual and specifications below to ensure that it delivers no more than the rated power (25Wrms) to the C25V.
Specifications
Stock ref. 952.820UK 952.821UK
Colour White Black
Driver 65mmØ (2.5“) reinforced paper cone
Frequency response (-10dB) 150Hz - 22kHz
Impedance 8 Ohms
Power max. : 8 Ohms 30W
Power rms : 8 Ohms 15W
Power rms: 100V line 6W
Sensitivity (1m, 1W) 88dB
Dimensions (each) 89 x 111 x 90mm
Weight (each) 465g
Errors and omissions excepted.
Copyright© 2013. AVSL Group Ltd.