AEG F78420VI0P - Manual (Page 32)

Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is
not sufficient. Adjust the rinse aid se-
lector to a higher position.
• The quality of the detergent can be
the cause.
Dishes are wet
• The programme is without a drying
phase or with a low temperature dry-
ing phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the
cause.
• The quality of the combi detergent
tablets can be the cause. Try a differ-
ent brand or activate the rinse aid dis-
penser and use rinse aid together with
the combi detergent tablets.
Refer to ‘HINTS AND TIPS’ for
other possible causes.
10.2 How to activate the rinse
aid dispenser
The activation of the rinse aid dispenser
can occur only with the Multitab option
activated.
1. Press the on/off button to activate
the appliance. Make sure that the ap-
pliance is in setting mode, refer to
“Setting and starting a programme”.
2. Press and hold, at the same time,
buttons (4) and (5) until the indicators
of buttons (3), (4) and (5) start to flash.
3. Press button (4).
• The indicators of buttons (3) and (5)
go off.
• The indicator of button (4) contin-
ues to flash.
• The display shows the current set-
ting.
Rinse aid dispenser off.
Rinse aid dispenser on.
4. Press button (4) to change the set-
ting.
5. Press the on/off button to deactivate
the appliance and to confirm the set-
ting.
6. Adjust the released quantity of rinse
aid.
7. Fill the rinse aid dispenser.
11. TECHNICAL INFORMATION
Dimensions Width / Height / Depth
(mm) 446 / 818 - 898 / 550
Electrical connection Refer to the rating plate.
Voltage 220-240 V
Frequency 50 Hz
Water supply pressure Min. / max. (bar / MPa) (0.5 / 0.05 ) / (8 / 0.8 )
Water supply
1)
Cold water or hot water
2) max. 60 °C
Capacity Place settings 9
Power consumption Left-on mode 0.10 W
Off-mode 0.10 W
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
2) If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
32 www.aeg.com