AVSL 171.818 VN2 - Manual (Page 2)

QTX VHF Wireless User Manual
Introduction
Thank you for choosing the QTX Sound VHF-series wireless system. This professional wireless set provides a high quality
microphone with VHF radio system for freedom of movement without loss of audio quality. Please read this manual
before using this equipment in order to avoid damage through incorrect operation and to get the best performance from
your purchase.
Contents:
Please take care when unpacking this product. Inspect for any damage and ensure you have the following components…
 VHF wireless receiver
 Mains power adapter
 6.3mm mono jack lead
 9V battery, PP3 (2 pieces for VH2, VN2 or VHN2)
 Microphone / transmitter(s) – see table below
Model Stock code
Microphone 1 Microphone 2
VH1 171.804 / 171.805 Handheld transmitter -
VH2 171.816 / 171.817 Handheld transmitter Handheld transmitter
VN1 171.836 / 171.837 Neckband mic. + bodypack -
VN2 171.818 / 171.819 Neckband mic. + bodypack Neckband mic. + bodypack
VHN2 171.810 / 171.811 Handheld transmitter Neckband mic. + bodypack
VL1 171.834 / 171.835 Lavalier mic. + bodypack -
Warning
To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.
If liquids are spilled on any component, stop using immediately, allow unit to dry out and have checked by qualified
personnel before further use.
Avoid impact or heavy vibration to any of the components, dropping the microphone can cause capsule failure.
No user serviceable parts inside transmitter or receiver - refer servicing to qualified service personnel.
Safety
 Ensure that the correct adapter is used with adequate current rating and that the mains voltage is as stated on the
adapter.
 Avoid ingress of water or particles into the transmitter(s) or receiver
 Use alkaline or NiMH batteries in the transmitter(s) and remove if unused for long periods.
 Observe the correct polarity when replacing batteries
Placement
 Keep all components out of direct sunlight and away from heat sources.
 Do not place heavy objects on top of the receiver or transmitter(s)
 If rack-mounting, secure the receiver to a 1U rack tray and do not place heavy equipment above the receiver.
 Keep the transmitter(s) and receiver away from damp or dusty environments.
Cleaning
 Use a soft cloth with a neutral detergent to clean the body of the microphone/transmitter and receiver.
 Lightly damp sterile wipes may be used on the microphone grille for hygiene purposes
 To avoid damage, do not use solvents to clean the components