AVSL 661.131 LPSA90 - Manual (Page 2)

the wall for 1 minute and plug back in. The Blue and Green LED will be lit together for 3 seconds to
indicate memory erase. Repeat process one to search for the right working voltage for the new laptop.
Please note
– device may remained standby when connected to certain model of laptop at power off, this may
require switch on the laptop to start the device. Please refer to Manual Operation if device remained standby.
When laptop is switched off, the device will remain working until the battery is fully charged before automatically
switched off to standby mode.
MANUAL mode:
Manual mode will allow to selector working voltage of “15-16V” or “19.5V”
1- Connect the AC power to the device, the Blue and Green LED will light once to indicate the device is
powered up.
2- Refer to the bottom of the laptop for the operation voltage required and push the slider to the appropriate
voltage for the laptop. For voltage between 15-16.5V please push slider to “15-16V”, for voltage between
18- 20V please push slider to “19.5V”. (please ensure the working voltage required is within the adaptor’s
working voltage range.)
3- Select the tip that is compatible with your laptop and connects it to the DC output tip, the fixed tip on this
product is 5.5 x 2.5mm.
4- Connect the device to the laptop, the Green LED will be lit to indicate it is working and supplying power to
the laptop.
5- When laptop is standby or switched off, the device will enter standby mode too. This indicates by the LED
remained switched off. When the laptop is switched on on the next use, the device will automatically
switch back on.
Please note
– if laptop is connected with the wrong selected voltage, this may cause the laptop unable to start up
properly. Remove the device and battery from the laptop for 10 seconds. Reinstall the battery and connect the
laptop at the correct voltage again will allow the laptop to start properly again.
Important Notice:
- Only use DC tip supplied with the device, use of any other tips may cause damage to device and laptop.
- When not intended to use for a long period of time, please unplug the device from the main.
- Device temperature may increase when operating. Please avoid locate device on cotton, fiber, leather
and fur material etc, which may cause damage to the device.
- Do not disintegrate device.
- Operation ambient temperature: 0°C to 25°C
Storage temperature: -20°C to 60°C
This “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or Electronic equipment and should
not be disposed with other household or commercial waste at the end of its useful life. The goods must be disposed of according to your local
council guidelines.
Errors and omissions excepted.
Copyright© 2013. AVSL Group Ltd.