AVSL Citronic CDM8:4 USB User Manual
Page 6
CDM8:4 USB User Manual
Rear Section:
35.
Mains inlet – IEC connector to connect to mains using the supplied lead
36.
Fuse Holder – 20mm mains fuse holder - please note correct rating when replacing
37.
RETURN L+R – When these 6.3mm jacks are connected to the outputs of an external
processor, the output of the external unit will override the internal digital delay effect for
Vocal mics 1 + 2.
38.
SEND – Mono 6.3mm jack to connect to the input of external processors, sending the effect
mix from Vocal mics 1 + 2.
39.
OUTPUTS BALANCED – Balanced XLR L + R main mix outputs
40.
OUTPUTS UNBALANCED – Unbalanced RCA main mix outputs
41.
BOOTH OUT – RCA outputs governed by BOOTH LEVEL control (30)
42.
REC OUT – High frequency cut/boost for each stereo channel
43.
CHANNEL 4 LINE – RCA L+R inputs for line level source (CD, DVD, MP3, PC etc.) (this
input is switchable with the top panel 3.5mm stereo MP3 input)
44.
CHANNEL 4 PHONO – RCA L+R phono inputs for turntable
45.
CHANNEL 3 LINE – RCA L+R inputs for line level source (CD, DVD, MP3, PC etc.)
46.
CHANNEL 3 CD – RCA L+R inputs for CD player (or other line level source)
47.
Ground (earth) – Screw terminal for grounding equipment to the case of the CDM8:4 USB.
Attach turntable ground spade connectors here.
48.
CHANNEL 2 LINE – RCA L+R inputs for line level source (CD, DVD, MP3, PC etc.)
49.
CHANNEL 2 CD – RCA L+R inputs for CD player (or other line level source)
50.
CHANNEL 1 LINE – RCA L+R inputs for line level source (CD, DVD, MP3, PC etc.)