AVSL 952.980 AD-200 - Manual (Page 6)

17. +10 BUTTON – Skips 10 tracks for faster searching
18. PROGRAM BUTTON – Used to enter programming mode and play tracks in a particular
order
19. MODE BUTTON – Select either:
a. PLAY ALL – All programmed tracks will be played in sequence.
b. REPEAT TRACK – The programmed track will repeat.
c. REPEAT ALL – All tracks will play in sequence and then repeat.
d. RANDOM REPEAT – All tracks will repeat in random order.
20. IR SENSOR – Remote sensor do not cover.
21.
FUSE – Under normal conditions the fuse should not blow. If it does then it usually
indicates an overload condition. To change the fuse remove the power cord and using a
flat blade screw driver remove the fuse and replace with the same rated fuse (indicated
on the rear of the unit)
22. VOLTAGE SWITCH – DO NOT UNDER ANY CIRCUMSTANCES CHANGE THE VOLTAGE. It
will invalidate your warranty and cause serious damage to the unit. Your voltage is
preset for your country. Only if you travel to a country that operates 110V should you
change this switch.
23. RCA OUTPUT – Unbalanced outputs.
24. XLR OUTPUT – Balanced output