AVSL 499.921 PROFESSIONAL METAL DETECTOR - Manual (Page 4)

- 4 -
Cautions:
♦ The search coil’s plug fits into the connector only one way. Do not force
the plug or you could damage it.
♦ To disconnect the search coil’s cable from the detector, grasp the plug
and pull it out of the connector. Never pull on the cable.
7. Loosen the knob at the search coil’s end, then adjust the search coil to
the desired angle. (The search coil should be parallel with the ground.)
tighten the knob just enough to keep the search coil from rotating or
wobbling.
Caution: Do not overtighten the search coil or use tools such as pliers
to tighten it.
8. Loosen the knob at the base of the handle, insert the arm support, and
tighten the knob.
INSTALLING BATTERIES
You need three 9-volt alkaline batteries to power your detector.
Cautions:
♦ Use only fresh batteries of the required size and recommended type.
♦ Do not mix old and new batteries, different types of batteries (standard,
alkaline, or rechargeable), or rechargeable batteries of different
capacities.
1. If the detector is on, turn MODE to OFF.
- 49 -
PRAKTISK BRUG.
Hold søgespolen ca. 5 cm over jorden og bevæg den langsomt fra side til
side.
Hold hele tiden søgespolen parallelt med jordoverfladen.
Lyt hele tiden efter lydsignalet og hold øje med viseren.
HUSK! Metaldetektoren reagerer på alle slags metaller også de værdiløse.
FIN-INDSTILLING AF DETEKTOREN.
Denne indstilling gør det lettere at skelne mellem forskellige metaller, og
lokalisere dem mere præcist, specielt når man først har lært
metaldetektoren at kende. Indstillingen gennemgås her knap for knap.