Braun 7690 Syncro System Smart Logic - Manual (Page 10)

10
English
Our products are designed to meet the highest standards
of quality, functionality and design.
We hope you enjoy your new Braun shaver.
Your Braun Syncro is supplied with a Braun Clean&Charge
(please see separate use instructions).
SmartLogic Inside
The «SmartLogic» electronics inside your shaver analyzes
your personal shaving patterns and the type of beard you
have, and then adapts the battery care and cleaning cycles
to ensure optimal performance.
Warning
Your shaver is provided with a low voltage adaption
system. Therefore you must not exchange or manipulate
any part of it. Otherwise there is risk of electric shock.
Technical specifications:
• Wattage via low voltage cord: 7 W
• Power supply via mains adapter, input voltage:
100-240 V ~/50 or 60 Hz (automatic adaptation)
• Shaver input voltage: 12 V
Description
1 Foil protection cap 7 Display
2 Shaver foil 8 Info key
3 Cutter block 9 Pilot light
4 Foil release button 10 Shaver socket
5 Long hair trimmer 11 Power supply cord set
6 Switch
Charging the shaver
• First charging: Using the power supply cord set,
connect the shaver to the mains with the switch on
position «0» and charge it for at least 4 hours
(plug might get warm). From now on, the SmartLogic inside
your shaver will ensure optimal care of the battery.
• A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth.
However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
• Best environmental temperature range for charging is
15 °C to 35 °C.
+35
°
C
+15 ° C
21
0
7664
5491384_S 4-82 Seite 10 Mittwoch, 18. September 2002 9:00 09