Babyliss C1000E Curl Secret - Manual (Page 7)

7
Please refer to the table below :
Time Audio beep indicator Curl effect
8 8 seconds 3 beeps Loose waves
10 10 seconds 4 beeps Soft curls
12 12 seconds 5 beeps Defined curls
• Ensure the section of hair is clean, dry and perfectly combed
through.
• Clip the upper layers to the top of your head to work first with the
layers underneath.
• Separate a section of hair no bigger than 3 cm. Ensure the section
is combed through.
• The appliance must be positioned into the hair with the cylinder
facing towards the head. (FIG 1, 2).
• The hair section must be straight and placed neatly through the
centre of the appliance, between the handles.
• Once the hair is in place, close the handles to allow the hair to be
automatically taken into the appliance.
Note : If you continue to hold the hair section after closing the
handles then the styler will stop and beep to indicate that you
must release the tension on the hair. (FIG 3, 4). If you have
taken too much hair (a section of hair bigger than 3 cm) or the
hair is not neatly going through the centre of the appliance, the
styler will again stop and beep to indicate a problem. This safety
feature ensures that there will be no tangles.
• Continue to hold the handles closed until the end of the individual
beeps (after 3, 4 or 5 beeps depending on the selected time setting,
see the table hereabove).
• Release the appliance from the hair by opening the handles fully.
Do not pull away the appliance from the hair, it will straighten the
curl out (FIG 5).
• Allow your hair to cool before handling or combing.
• Repeat around the head until you have the amount of curls desired.
Note : The styler is equipped with an alternating curl direction
automatic system for a natural finish (FIG 6).
• After use, switch off and unplug the appliance. Allow to cool before
storing away.
C1000E IB-leaflet.indd 7 6/27/13 2:18 PM