C2G 29558 PORT AUTHORITY 2-PORT FIREWIRE PC-CARD - Manual

PORT AUTHORITY 2-PORT FIREWIRE PC-CARD MANUAL
System Requirements:
Hardware:
• A Pentium Pro  , Pentium III,IV  or later Notebook with 32-bit Cardbus
(PCMCIA) slot
Software:
• Windows® 98SE/ME/2000/XP
Package Contents:
• Installation Guide
• The Port Authority FireWire (IEEE-1394) PC-Card
• This manual
Software driver installation
The versions of Windows listed above have built-in support for this FireWire card.
No additional drivers are required. When you first connect your FireWire 1394
card and power on your PC, Windows will automatically detect the new device and
start the New Hardware Wizard. Please follow the step-by-step instructions below
on how to properly install the required software drivers.
Follow the steps listed below to install the Windows
   
98 SE/ME drivers:
1. Turn on your notebook with Windows® 98SE/ME.
2. Insert the IEEE-1394 Card into the computer’s PCMCIA slot.
3. Under the Add New Hardware Wizard, click Next.
4. Select the option “Search for the best driver for your devices
(Recommended)“ and click Next.
5. Uncheck all of the option checkboxes then click on Next.
6. Click Next and then Finish respectively.
To Verify Successful Installation in Windows

98SE/ME
1. From the main desktop, double-click My Computer, double-click Control
Panel, System, then Device Manager.
2. You should see a category called 1394 Bus Controller, and a device called PCI
OHCI Compliant IEEE-1394 Host Controller (or something similar).
Windows® 2000 Driver Installation
1. Turn on your notebook with Windows® 2000.
2. Insert the IEEE-1394 Card into the computer PCMCIA slot.
3. Windows
 2000 will install the default driver automatically.