C2G 29342 USB SuperBooster Wall Plate - Manual (Page 3)

Installing your USB SuperBooster Wall Plate
The USB SuperBooster Wall Plate has a transmitter unit and a receiver unit. Make
certain you install the transmitter unit at your computer or source side.
The receiver unit needs to be installed on the device side.
1) Install the Transmitter unit in a standard J-box where you want your
source/computer
2) Install the Receiver unit in a standard J-box where you want your USB device
3) Use a pre-terminated Cat5/Cat5E/Cat6 cable (recommended) or terminate your
own cable using the tool-less RJ45 connectors included to connect the two wall
plates together (see below for instructions on terminating your own cable)
4) Plug your computer into the source end (USB B side) using a standard A/B USB
cable (The green LED will light to indicate you have a good connection to the
wall plate)
5) Plug your device into the receiver end (USB A side) using a standard A/B (or
A/Mini-B) USB cable (The green LED will light to indicate you have a good
connection to the wall plate)
6) Turn your computer/source on and begin using your device
Terminating a Cat5/Cat5E/Cat6 Cable Using the Tool-less IDC
1) Open the plug by lifting the clear plastic end
2) Pin 1 of the connector is on the left side of the clear plastic shell while Pin 8 is on
the right side of the connector (with RJ45 connector facing away from you)
3) Thread the white/orange conductor on your Cat5/5E/6 cable into Pin 1
4) Thread the orange conductor on your Cat5/5E/6 cable into Pin 2
5) Thread the white/green conductor on your Cat5/5E/6 cable into Pin 3
6) Thread the blue conductor on your Cat5/5E/6 cable into Pin 4
7) Thread the white/blue conductor on your Cat5/5E/6 cable into Pin 5
8) Thread the green conductor on your Cat5/5E/6 cable into Pin 6
9) Thread the white/brown conductor on your Cat5/5E/6 cable into Pin 7
10) Thread the brown conductor on your Cat5/5E/6 cable into Pin 8
11) Repeat steps 1-10 to terminate the other end of your Cat5/5E/6 cable
Pin 8
Pin 1
2