C2G 29344 USB SuperBooster - Manual (Page 2)

Introduction
Thank you for purchasing the USB SuperBooster Transmitter Wall Plate. The USB
SuperBooster Transmitter Wall Plate is one component of a complete solution that, when
paired with a receiver (sold separately) allows you to conquer USB length limitations and
put your USB devices where you need them. This wall plate solution extends the distance
of a USB device to a host computer up to 150ft so you can place your USB projector,
camera, printer, or other USB device exactly where you want it! The USB SuperBooster
Wall Plate is powerful yet simple, with no drivers to install or special software required.
It is also compatible with any computer that supports USB.
This plug-and-play device consists of a transmitter unit and receiver unit incorporated
into single gang Decora compatible wall plates or dongles. Numerous receiver options
are available so you can customize the configuration to meet your own needs. Choose
from a two-port wall plate receiver, a two-port dongle receiver, or a four-port dongle
receiver. These options are ideal for applications where you need more than one USB
device on the receiver side or you need a dongle instead of a wall plate on the receiver
side.
The transmitter/receiver pair is connected via standard Cat5, Cat5E, or Cat6 UTP cable
allowing for easy in-wall installation. This makes for a clean, finished installation
important for home owners, classrooms, offices and anywhere you don’t want visible
cables lying around. Use pre-terminated network cables or pull un-terminated cable and
use the included tool-less IDC RJ45 connector. The USB SuperBooster Wall Plate is bus-
powered so no external power source is required.
1