C2G 52064 Single Port KVM over IP - Manual

1 / 2
AMENDMENT
Chapters 1 & 4.1
In factory default, DHCP mode is disabled (IP auto configuration = None), and the IP
settings are as below:
IP address 192.168.1.22
Subnet mask 255.255.255.0
Default Gateway None
Chapter 4.1
The new network setup tool PSetup can be obtained from your distributor.
Chapter 5.4.1 (Video Settings)
If you are experiencing the remote control screen displaying a pinkish tint with
some graphic cards, please try adjusting the brightness of the remote console by
following steps below.
(1) Click Video Settings in Options menu of the remote console.
(2) Adjust the Brightness setting until the pinkish tint is reduced or eliminated.
Chapter 6.2.3.2
The KVM Vision Viewer utility is not longer supported.