C2G 28653 Docking Station with Video - Manual (Page 16)

Docking Station with Video User’s Manual
C. Connecting the Docking Station to Computer
1. Assemble the docking station by sliding the main body onto the base plate to
make it self-standing.
2. Plug the power cord of the power adaptor into the DC IN jack on the back of the
docking station and then connect the power adapter to a working electrical outlet.
The Power indicator on the front panel glows when the docking station is
powered on.
3. Plug the square end of the USB cable into the USB upstream connector at the
back of the docking station.
4. Plug the other end of the USB cable into an available USB 2.0 port on your
computer.
Upon the USB connection, your computer will automatically complete the remaining
installation, including installing Windows built-in drivers for the USB hub.
A pop-up message will appear in the notification area indicating the installation status.
Wait for the final message indicating the driver software installation is successful.
Then the docking station is ready for use.
D. Connecting Devices to the Docking Station
Now the installation is complete. You can connect the peripherals/monitor to
appropriate ports on the docking station as required. If required, you can connect and
disconnect the peripherals/monitor any time without disconnecting the docking
station from the USB port on your computer.
Connecting Ethernet network device
1. Connect an Ethernet cable to the Ethernet port on the docking station.
2. Connect the other end of the Ethernet cable to your network hub, switch or
router.
Connecting VGA/DVI Monitor
 For DVI model: The equipped DVI-I (DVI-Integrated) connector transmits both
the digital and analog signals. This means it supports either of these two
connection types:
 It can be connected to a DVI-D (digital) monitor using a DVI cable (not
provided)
12