Ab c, Video, Audio – C2G 41064 Video_Audio Distribution Amplifier AV400SV User Manual

Page 2: Cable electronics, inc, General information, Safety instructions, Key information

Advertising
background image

The AV400SV allows any audio/video source to distribute S-video and/or
composite video with left and right audio. The signal ratio is true one to one
with no loss from original source to four different locations. These locations
must have the same application as your audio/video source.

GENERAL INFORMATION

Location: Avoid locations with strong vibrations, direct sunlight or intense
heat. Avoid Electrical Shock: Do not handle power cord with wet hands; do not
expose to rain or other moisture. If liquid is spilled on unit, unplug and have
unit serviced at authorized service center. To reduce the risk of electrical
shock, do not remove cover. No user serviceable parts inside.

SAFETY INSTRUCTIONS

Audio/Video Source

VIDEO

Gain:

2 Volt Unterminated,
1 Volt Terminated: 75 ohm +5%

Input Impedance:

75 ohms +5%

Output Impedance:

75 ohms +5%

Video Insertion Loss:

50 Hz to 10 MHz < 40dB

In to Out Isolation:

50 Hz to 10 MHz 32 dB
port to port

Out to In Isolation:

50 Hz to 10 MHz 60 dB

Return Loss:

50 Hz to 10 MHz 20 dB

Video Bandwidth:

> 10 MHz

Audio Response:

> 100 KHz

AUDIO

Gain:

Unity

Input Impedance:

22 K ohm

Output Impedance:

1 K ohm

THD:

0.05% at 1.0 Volts input level

Frequency Response:

20 Hz to 100 KHz

Channel Separation:

> 75 dB @ 1 KHz

In to Out Isolation:

60 dB

Out to In Isolation:

60 dB

Signal to Noise:

100 dB (re: 2 Volts out)

A/V Input/Output Jacks:

RCA type Phono Jack

A. 15 Volt DC input jack at 600MA with 2.5 mm power jack. LED lights up

when power is applied.

B. Input Jacks: Connect to original source at corresponding output jacks.

Composite connections are color coded (red to red, yellow to yellow and

white to white) with S-video to S-video.

C. Output Jacks: Connect to corresponding input jacks of TVs, VCRs, etc.

A

B

C

The AV400SV can be looped, cascaded or put in tandem as shown without
loss of audio/video signals. Audio/Video cables need to be top quality and can
have runs of up to 100 feet between units and 150 feet between units and TVs.

KEY INFORMATION

Common Audio/video Sources:

VCR, CD, Satellite receiver, etc.

HIGH PERFORMANCE

AUDIO AND VIDEO

WITH S-VIDEO

Four Output

True One To One Ratio

Model 400SV

CABLE ELECTRONICS, INC.

DISTRIBUTION AMPLIFIER

S-VIDEO

COMPOSITE

S-VIDEO

HIGH PERFORMANCE

AUDIO AND VIDEO

WITH S-VIDEO

Four Output

True One To One Ratio

Model 400SV

CABLE ELECTRONICS, INC.

DISTRIBUTION AMPLIFIER

S-VIDEO

COMPOSITE

S-VIDEO

HIGH PERFORMANCE

AUDIO AND VIDEO

WITH S-VIDEO

Four Output

True One To One Ratio

Model 400SV

CABLE ELECTRONICS, INC.

DISTRIBUTION AMPLIFIER

S-VIDEO

COMPOSITE

S-VIDEO

S-VIDEO

Advertising