Braun 199s-1 Series 1 - Manual (Page 6)

6
Our products are designed to meet the highest standards of quality,
functionality and design. We hope you entirely enjoy your new Braun shaver.
Caution
For usage in other body areas, please make sure that the skin is stretched.
For hygienic reasons, do not share this appliance with other persons.
Description
1a Foil protection cap
1b Shaver foil
2 Cutter
block
3 Foil release button
4 On/off
switch
5 Long hair trimmer
6 Charging light (green)
7 Low charge light (red) (only model 199s)
8 Special cord set
Charging
• The best environmental temperature for charging is between 60 °F to
95 °F / 15 °C to 35 °C. Do not expose the shaver to temperatures higher
than 122 °F / 50 °C for extended periods of time.
• Using the special cord set, connect the shaver to an electrical outlet with
the motor switched off.
• When charging for the first time or when the appliance is not used for a
few months, leave the appliance to charge continuously for 4 hours.
• The charging light shows that the appliance is being charged. When the
battery is fully charged, the charging light turns off. Intermittent blinking
after a while indicates that the battery maintains its full capacity. This can
also happen short term when charging after the battery was completely
discharged.
• Once the shaver is completely charged, discharge the shaver through
normal use. Then recharge to full capacity. Subsequent charges will take
about 1 hour.
• A full charge provides up to 40 minutes of cordless shaving time
depending on your beard growth. However, the maximum battery capacity
will only be reached after several charging/discharging cycles.
• The red low-charge light (7) (only model 199s) flashes when the battery is
running low. You should be able to finish your shave.
99768296_199_197_195s_NA_S4-30.indd 6 99768296_199_197_195s_NA_S4-30.indd 6 10.02.11 09:38 10.02.11 09:38