Braun 6690 FreeGlider User Manual
Page 12
12
What to do if ...
Problem
Situation
Solution
Shaving Conditioner is leaking
Foil frame replaced incorrectly Remove foil frame and attach once more,
ensuring both sides click audibly into
place. If needed, clean both foil frame and
shaver head.
or
Applicator replaced
incorrectly
Place new applicator on the foil frame,
leaving a small gap. With both thumbs
push applicator right and left until it clicks
into place.
or
Shaver was switched on with
foil frame removed
Do not switch on when foil frame is
removed.
or
Cartridge was removed
immediately after use
Do not remove cartridge immediately after
use.
None, or too little Shaving
Conditioner dispensed with
new shaver
No cartridge inserted
or
Sealing foil not removed from
cartridge
or
Scale positioned at «min»
Insert cartridge.
Remove sealing foil.
Move scale.
None, or too little Shaving
Conditioner dispensed after
longer use
Applicator clogged
or
Cartridge empty
Replace applicator (before shaving do
not use moisturizing creme or lotion).
Insert new cartridge.
Skin is red or burns
Skin is not used to Shaving
Conditioner
Conditioner contains alcohol. Sensitive
skin might require 1 to 2 weeks to get
accustomed. If your skin shows signs of
intolerance, discontinue using the Shaving
Conditioner.
Shaver is connected to the
mains, but is not charging
(green LED does not light up)
Shaver is completely
discharged
Leave shaver connected to the mains,
push start/stop button once. Shaver will be
charging when green LED lights up.
Shaving head does not swivel
Head lock activated
Release head lock.
Cartridge cannot be removed
Pull-out tag was accidentally
removed from cartridge
Use appropriate tool (flat-nose pliers) to
pull out cartridge. When inserting a new
cartridge, only remove the silver sealing
foil. Do not remove the transparent pull-out
tag.
Water condensation inside the
cartridge compartment
Differences in temperature
when cleaning with water
Condensation will disappear after a
while and has no effect on the shaver’s
operation. The electronics section is sealed
against water.
5710458_S4-34 Seite 12 Freitag, 8. August 2003 9:31 09