Zanussi ZDT16003FA - Manual (Page 27)

Problem Possible cause Possible solution
The appliance door is open. Close the appliance door.
The fuse in the fuse box is damaged. Replace the fuse.
The delay start is set. Cancel the delay start or wait for the
end of the countdown.
The appliance does not fill
with water. The water tap is closed. Open the water tap.
The water pressure is too low. Contact your local water authority.
The water tap is clogged or there is
limescale on it. Clean the water tap.
The filter in the water inlet hose is
clogged. Clean the filter.
The water inlet hose has a kink or a
bend. Make sure that the position of the
hose is correct.
The anti-flood device is on. There are
water leakages in the appliance. Close the water tap and contact the
Service.
The appliance does not
drain the water. The sink spigot is clogged. Clean the sink spigot.
The water drain hose has a kink or a
bend. Make sure that the position of the
hose is correct.
After the checks are completed, activate the
appliance. The programme continues from the
point of interruption.
If the problem occurs again, contact the Serv-
ice.
If the display shows other alarm codes, contact
the Service.
If the washing and drying results are not
satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released quantity of rinse aid is too
much. Adjust the rinse aid selector to a lower
position.
• The quantity of detergent is too much.
Stains and dry water drops on glasses
and dishes
• The released quantity of rinse aid is not suffi-
cient. Adjust the rinse aid selector to a higher
position.
• The quality of the detergent can be the
cause.
Dishes are wet
• The programme is without a drying phase or
with a low temperature drying phase.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• The quality of the combi detergent tablets
can be the cause. Try a different brand or ac-
tivate the rinse aid dispenser and use rinse
aid together with the combi detergent tab-
lets.
Refer to ‘HINTS AND TIPS’ for other pos-
sible causes.
Activating the rinse aid dispenser with the
multitab function activated
1. Press the on/off button to activate the appli-
ance. Make sure that the appliance is in set-
ting mode, refer to ‘SETTING AND START-
ING A PROGRAMME'.
2. Press and hold function buttons (B) and (C)
at the same time until the indicators of func-
tion buttons (A), (B) and (C) start to flash.
3. Press function button (B).
27
www.zanussi.com