Braun 7505 Syncro DE - Manual (Page 8)

8
Our products are designed to meet the highest standards
of quality, functionality and design. We hope you enjoy
your new Braun shaver.
Important
Only use the power supply cord set provided.
A damaged cord must be replaced immediately.
Description
1 Foil protection cap 7 Charging lights
2 Shaver foil
(green)
3 Cutter block 8 Low-charge light
4 Foil release button (red) 7520, 7515 only
5 Long hair trimmer 9 Pilot light
6 Switch 10 Shaver socket
Technical specifications:
• Wattage via cord set: 7 W
• Power supply via cord set: 100-240 V
2 /50 or 60 Hz
(automatic adaptation)
• Shaver input voltage: 12-24 V
Charging the shaver
• First charging: Using the power supply cord set,
connect the shaver to the mains with the switch
on position «0» and charge it for at least 4 hours
(plug might get warm).
• Once the shaver is completely charged, shave without
the cord until fully discharged. Then recharge to full
capacity again (subsequent charges will take about
1 hour).
• A full charge will give up to 50 minutes of cordless
shaving time depending on your beard growth.
However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
• Best environmental temperature range for charging is
15 °C to 35 °C.
Indicator lights
• The pilot light shows that the shaver is connected to
the mains.
+35 °C
+15 °C
21
0
7570
English
5493458_S 4-66 Seite 8 Montag, 4. September 2000 3:02 15