Braun 5614 Flex XP - Manual (Page 6)

6
Our products are designed to meet the
highest standards of quality, functionality and
design. We hope you enjoy your new Braun
shaver.
Warning
Your shaver is provided with a low voltage
adapter. Therefore you must not exchange or
manipulate any part of it. Otherwise there is
risk of electric shock
Technical specifications
Wattage via cord set: 7 W, automatic power
supply: 100–240 V
2 / 50–60 Hz
Description
1 Shaver foil
2 Cutter block
3 Release button
4 On/off switch
5 Long hair trimmer
6 Dual function light: charging/low charge
7 Special power supply cord set
Charging the shaver
• First charging: Using the power supply cord
set, connect the shaver to the mains with
the motor switched off. Charge it for at least
4 hours (shaver and adapter might get
warm). Once the shaver is completely
charged, shave until fully discharged. Then
recharge to full capacity again (subsequent
charges will take about 1 hour).
• When green, the dual function light indi-
cates that the shaver is being charged.
When the rechargeable battery is fully
charged, the green light goes off. If later on,
the green light comes on again, this indi-
cates that the shaver is being recharged to
maintain its full capacity.
• When red, the dual function light indicates
that the battery capacity has dropped below
20%, provided the shaver is switched on.
The remaining capacity will then be
sufficient for 2 to 3 shaves.
• A full charge will give up to 50 minutes of
cordless shaving time depending on your
beard growth. However, the maximum
battery capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature range for
charging is 15 °C to 35 °C.
• Shaving with the cord: If the rechargeable
battery is discharged, you may also shave
with the shaver connected to the mains via
the power supply cord set.
Shaving
Turn on the shaver («start»):
The pivoting cutting system automatically
adjusts to every contour of your face.
Trimmer:
When the long hair trimmer is activated, it
allows the controlled trimming of moustache
or sideburns.
Keeping your shaver in top
shape
Cleaning under running water
After each shave, turn on the shaver and clean
it under running hot water. Occasionally use
soap (natural based liquid soap without
particles and abrasive substances). Then rinse
off all foam and let the shaver run for another
moment.
Tips for the perfect shave
• We recommend that you shave before
washing, as the skin tends to be slightly
swollen after washing.
• Hold the shaver at right angles (90°) to the
skin. Stretch your skin and shave against
the direction of beard growth.
• To ensure optimum shaving per-
formance, we recommend to replace the
shaver foil and cutter block every 18
months, or when the parts are worn.
English
5723450_5614_MN Seite 6 Donnerstag, 11. April 2002 3:52 15