Acer P1273 - Manual (Page 56)

46
English
To Change the Lamp
1
Turn off the projector by pressing the power button.
2 Allow the projector at least 30 mins to cool down.
3 Disconnect the power cord.
4 Open the screw cover on the right side of the projector. (Illustration #1)
5 Use a screwdriver to loosen the screw on the right side of the projector.
(Illustration #2)
6 Push and slide the top cover (Illustration #3) and then open the top cover.
(Illustration #4)
7 Loosen two screws on the lamp module (Illustration #5) and pull up the
lamp bar. (Illustration #6)
8 Pull out the lamp module by force. (Illustration #7)
To replace the lamp module, reverse the previous step.
Warning: To reduce the risk of personal injury, do not drop the
lamp module or touch the lamp bulb. The bulb may shatter and
cause injury if it is dropped.