Acer H5370BD User Manual
Page 48
38
En
gl
ish
To Change the Lamp
1
Turn off the projector by pressing the power button.
2
Allow the projector at least 30 mins to cool down.
3
Disconnect the power cord.
4
Open the screw cover on the right side of the projector. (Illustration #1)
5
Use a screwdriver to loosen the screw on the right side of the projector.
(Illustration #2)
6
Push and slide the top cover (Illustration #3) and then open the top cover.
(Illustration #4)
7
Loosen two screws on the lamp module (Illustration #5) and pull up the
lamp bar. (Illustration #6)
8
Pull out the lamp module by force. (Illustration #7)
To replace the lamp module, reverse the previous step.
Warning: To reduce the risk of personal injury, do not drop the
lamp module or touch the lamp bulb. The bulb may shatter and
cause injury if it is dropped.