Bell & Gossett G97035G Readout Valve, Readout Probe - Manual

Readout Valve
RV-125A
(G97030)*
RP-250B
(G97032)*
*SET OF TWO *SET OF TWO
FERRULE
NUT
*SET OF TEN
Readout Probe
INSTALLER: PLEASE LEAVE THIS MANUAL FOR THE OWNER’S USE.
NOTE: This product is not intended for use in potable water applications.
WARNING: California Proposition 65 Warning! This product contains chemicals known to the State of California to
cause cancer and birth defects or other reproductive harm.
SAFETY
INSTRUCTIONS
This safety alert symbol will be used in this man-
ual to draw attention to safety related instruc-
tions. When used, the safety alert symbol means
ATTENTION! BECOME ALERT! YOUR SAFETY IS IN-
VOLVED! FAILURE TO FOLLOW THESE INSTRUCTIONS
MAY RESULT IN A SAFETY HAZARD.
DESCRIPTION
The Readout Valve is equipped with an inte-
gral EPDM rubber check valve designed to mini-
mize system fluid loss when used with a RP-
250B Readout Probe to monitor pumps, heat exchang-
ers, valves, etc., handling hot or cold water.
CONNECTION SIZE
Readout Valve: 1/8" NPT and 1/4" NPT
Readout Probe: 7/16" – 20 UNF-2A THD Meter Connection
V58050PK*
PROTECTIVE
CAP
BODY
1/8" NPT 1/4" NPT
CHECK
VALVE
OPERATIONAL LIMITS
Working Pressure 300 PSIG
Temperature 250°F
INSTALLATION INSTRUCTIONS
W A R N I N G : H o t f l u i d s a n d / o r f l u -
id under pressure. Isolate the prod-
uct in which the readout valve is to be in-
stalled with shut off valves, or drain the sys-
tem. Make sure that all drainage from the sys-
tem has stopped and that the system tempera-
ture has cooled to 100° F or less. Vent off any pres-
sure prior to installation. Failure to follow these instruc-
tions could result in serious personal injury or death
and property damage.
1. Apply pipe joint compound to NPT end of read-
out valve body and install into NPT opening.
2. Tighten cap on top of the readout valve.
3. Repressurize the system.
INSTRUCTION MANUAL
G97035G