AEG F34030VI0 - Manual (Page 31)

After the checks are completed, activate
the appliance. The programme contin-
ues from the point of interruption.
If the problem occurs again, contact the
Service. If other alarm codes show, contact the
Service.
9.1 The washing results and drying results are not satisfactory
Problem Possible cause Possible solution
The dishes are not
clean. The filters are clogged. Clean the filters.
The filters are not correctly
assembled and installed. Make sure that the filters
are correctly assembled and
installed.
The spray arms are clog-
ged. Remove remaining soil with
a thin pointed object.
The programme was not
applicable for the type of
load and soil. Make sure that the pro-
gramme is applicable for
the type of load and soil.
Incorrect position of the
items in the baskets. Water
could not wash all items. Make sure that the position
of the items in the baskets is
correct and that the water
can easily wash all items.
The spray arms could not
turn freely. Make sure that the position
of the items in the baskets is
correct and does not cause
the blockage of the spray
arms.
The quantity of detergent
was not sufficient. Make sure that you add the
correct quantity of deter-
gent in the dispenser be-
fore you start a programme.
There was no detergent in
the detergent dispenser. Make sure that you add de-
tergent in the dispenser be-
fore you start a programme.
Limescale particles
on the dishes. The salt container is emp-
ty. Make sure that there is dish-
washer salt in the salt con-
tainer.
The set level of the water
softener is incorrect. Make sure that the set level
of the water softener agrees
with the water hardness in
your area.
The cap of the salt contain-
er is loose. Tighten the cap.
Whitish streaks and
stains or bluish lay-
ers on glasses and
dishes. The released quantity of
rinse aid is too much. Decrease the released
quantity of rinse aid .
ENGLISH
31