Xylem MY CONNECT Quick Guide - Manual

Thank you for choosing MJK Mµ Connect ® for this
installation.
My Connect ® provides advanced functions for
optimizing energy consumption of pump operation
including controlling inverters with functions such as
datalogging and communication to SRO systems.
My Connect ® is created for mudular construction
and prepared for DIN rail mounting including
bussystem in the DIN rail for simple mounting and
set-up of the unit
This quick guide is your initial guide for mounting
and set-up. For more detailed instructions we
recommend the Mµ connect
® users guide and the
Mµ connect ® website.
7. USB Connection
My Connect ® : USB type B, female
PC USB standard female
PC must have Instrument Link™ 5.0 or later installed
Download from
http://www.mjk.com/index.php?id=208
When mounting extra units, use DIN-BUS
(ordered separately)
500311 DIN bus (3DIV.)
for mounting the each I/O Unit
500312 DIN bus (6DIV.) for mounting the CPU Unit when adding I/O units
2. Mounting DIN bus and extra units 4. Power supply
Quick guide
Top Back
Top front
DC power supply:
11-30VDC, 8-40 VA
Depending on
confi guration
SUPPLY
11-30VDC
- +
BACKUP
BATTERY
- +
AC Supply:
10-24 VAC, 8-40 VA
Depending on
confi guration
SUPPLY
24VAC
N L
6. LED Signals
Power up:
All LEDS are lit followed by running light -
Once up and once down
Status:
Mµ Connect ® control unit is ready.
Communication:
Modem is resetting, or the signal for the
GSM modem is too low.
(Modem is reset once per hour)
Modem is reset and Mµ Connect ® is ready
to receive incoming signals.
The unit is being called and awaits
communication.
The unit is connected and data can be
transferred via modem and WiFi
ALARM:
There is an active alarm signal.
All LEDS are turned on shortly when the USB
is connected and in a 10 minute interval.
3s
3s
1s
0,5s
0,5s
Insert simcard and mount antenna for remote
connection. Use MJK application Instrument
Link™ to setup communication line and
receive warnings automatically via dedicated
connection.
5. Remote surveillance and read-
out via GSM/GPRS
1. Content of the package
• Mµ Connect ® RTU Unit
DC backup battery:
12 VDC, 2-30Ah
Mounting the Connect ® display
GND A B
CNET
15V
3.
205505 Connect ® Display
205509 Display mounting kit
Front
Red Gray White Black
←
1. DIN BUS for I/O Modules
2. Mount modules
on DIN-BUS rail
6 DIV 3 DIV