Xylem CONNECT Quick Guide User Manual
Page 21
21
If you wish to stop a pump in use, use the up/down arrows to select Stop
Pump and press OK.
If you need to start or stop one of the next pumps, press once more on the
down arrow from Stop Level P1.
Now P2 will be displayed in the lower right corner. Press the right soft key
below P2 and the screen will change to Pump 2.
Repeat the procedure as described above.
There are 4 views and icons of the Pump Status.
Operation status
of Pump
Icon Description
P1 Running
Digital output when the pump is running and the feed-
back signal is ok.
P1 Stopped
Digital output when the pump has stopped and the feed-
back signal is missing.
P1 Error
Digital output when the pump is in use and the feedback
signal is missing.
P1 Blocked
Digital output when the pump is not in use.
Note: By pressing the right soft key again, you will toggle between the
number of pumps chosen for Pump Control 1.
It is a prerequisite that Pump Control has been set up and “Create Overview
Screen” has been carried out.
Scroll with the arrow keys to see more information.