Xylem CHATTER Hardware Manual - Manual (Page 22)

9. Re-connect the pressure transmitter connector by turning the union clock-
wise.
10. Immerse the pressure transmitter into the pipe, and make sure that the
cable and the security wire hang freely inside the pipe to ensure reliable
measurements.
11. Mount the Chatter top at the base by turning the top approx. 1 cm
counter-clockwise, until the holes for the security padlock align.
Expect a slight drag over the last few millimeters. This is due to the activa-
tion of the intruder alarm (a magnetic switch between top and base).
Right WRONG!
Figure 14. Chatter Top Mounted Right and Wrong
12. Re-mount the padlock.
Data Logger
22 GB Chatter Hardware Manual 100416