Troubleshooting, I-alert™ condition monitor troubleshooting, I-alert – Bell & Gossett P2000642B i-ALERT Condition Monitor User Manual
Page 14: Condition monitor troubleshooting
Advertising
Troubleshooting
i-ALERT
™
Condition Monitor troubleshooting
Symptom
Cause
Remedy
There are no green or red flashing LEDs.
The battery is dead.
Replace the condition monitor.
The unit is deactivated.
Activate the condition monitor.
The unit is malfunctioning.
Consult your Xylem representative
for a warranty replacement.
The red LEDs are flashing, but the temperature and vibration
are at acceptable levels.
The baseline is bad.
Check the temperature and
vibration levels and reset the
condition monitor.
The unit is malfunctioning.
Consult your Xylem representative
for a warranty replacement.
Troubleshooting
12
i-ALERT
™
Condition Monitor Installation, Operation, and Maintenance Manual
Advertising