Braun 390cc-4 Series 3 - Manual (Page 8)

8
Description
1 Foil & Cutter cassette
2 Long hair trimmer
3 Precision setting switch (« ») (390cc/370cc only)
4 On/off switch
5 Charging lights (green)
6 Low-charge light (red)
7 Cleaning light (yellow)
8 Replacement light for shaving parts
9 Shaver power socket
10 Special electric cord set
11 Travel pouch (390cc/370cc only)
12 Protective cap (350cc only)
Charging
The best environmental temperature for charging is between 60 °F to 95 °F /
15 °C to 35 °C. Do not expose the shaver to temperatures higher than
122 °F / 50 °C for extended periods of time.
• Using the special electric cord set (10), connect the shaver to an electrical
outlet with the motor switched off.
• When charging for the first time or when the shaver is not used for a few
months, leave the shaver to charge continuously for 4 hours. Subsequent
charges will take about 1 hour.
• A full charge provides up to 45 minutes of cordless shaving time depend-
ing on your beard growth.
• Shave without the cord. With normal use the shaver will be charged auto-
matically after every cleaning in the Clean&Renew (see «C Clean&Renew»).
• Maximum battery capacity will only be reached after several charging/
discharging cycles.
• 5-minute quick charge (with the special electric cord set (10)) is sufficient
for a shave.
• If the rechargeable batteries are discharged, you may also shave by
connecting the shaver to an electrical outlet via the special electric cord set.
Charging lights
The green charging lights (5) show the charge status of the batteries. The
green charging light blinks when the shaver is being charged or switched on.
When the battery is fully charged, all green charging lights shine permanently,
provided the shaver is connected to an electrical outlet.
99778043_Floater390cc4_NA_S6-.indd 8 99778043_Floater390cc4_NA_S6-.indd 8 26.01.11 10:40 26.01.11 10:40