John Wood Commercial Storage Tanks 80G - 120G - Manual

Hand Hole
Clean Out
Floor Drain
6”
Drain pan
(Piped to Drain
as Illustrated)
Temperature and
Pressure Relief Valve
Connections Valve
1” NPT Relief
Not Provided
Relief Valve
Discharge
Line to
Suitable
Open Drain
Terminate 6”
Above Drain
Anode 119 GAL
Hot Outlet 2 NPT
Anodes 119 GAL & 80 GAL
Aquastat
Connection
3/4 NPT
Circulating
Connections
2 NPT
Drain Valve
3/4 NPT
80G - 120G INSULATED STORAGE TANK
INSTALLATION AND OPERATING INSTRUCTIONS
Read these instructions
thoroughly before starting
Please retain these instructions in
a safe location for future reference.
NOTE:
These instructions apply only to
this storage tank unit. The water
heating source or other
components of the system
s h o u l d b e i n s t a l l e d i n
a c c o r d a n c e w i t h t h e i r
instructions, provided by their
manufacturer.
FOR YOUR SAFETY:
*Do not store or use gasoline or other
flammable vapours or liquids in the vicinity
of this or any other appliance.
*Installation and service must be
performed by a qualified installer, service
agency, gas supplier, or electric utility.
WARNING:
Improper installation,
adjustment, alteration, service, or
maintenance can cause injury or property
damage. Refer to this manual. For
assistance or additional information,
consult a qualified installer, service
agency, gas/oil supplier, or the electric
utility.
WARNING:
If the information in these
instructions is not followed exactly, a fire,
explosion, or water damage may result
causing property damage, personal injury
or death.
MEETS OR EXCEEDS ASHRAE 90.1b 1999.
IMPORTANT CONSUMER NOTICE
These instructions have been written for the proper
installation, safe operation and maintenance of this storage
tank unit.
It is your responsibility to ensure that your insulated storage
tank is properly installed and cared for. FAILURE TO
FOLLOW THE INSTRUCTIONS IN THIS MANUAL MAY
RESULT IN SERIOUS BODILY INJURY AND/OR
PROPERTY DAMAGE. THOROUGHLY READ ALL
INSTRUCTIONS BEFORE YOU ATTEMPT TO INSTALL
OR OPERATE THIS UNIT.
Installation and service require trade knowledge in the area
of plumbing, electricity, venting, air supply, and gas supply.
Installation is required by a qualified tradesperson in
accordance with National/Local Codes.
The manufacturer of this insulated storage tank cannot be
held liable for those damages caused by improper
installation, sizing, or failure to comply with these
instructions. PROTECT YOUR WARRANTY: Regularly
maintain your unit as detailed in the service and
maintenance section of this manual.
PART NO. 71768 REV. A (05-03)
FIGURE 1.
PART NO. 62607 REV. A (03-08)