Extron Electronics BUC 202 Setup Guide - Manual (Page 4)

BUC 202 • Setup Guide (Continued)
Mounting to Rack Rails Using a ZipClip
1. Fasten the ZipClip 200 mounting
clip to a rack rail using two rack
screws as shown in the
diagram on the right.
2. Insert the BUC 202 into the ZipClip
as described previously and press to
snap it into place.
Mounting to a Rack Shelf
The BUC 202 is one-quarter rack width wide.
Up to four BUC 202 units can be mounted side
by side directly onto a rack shelf.
1. Align the threaded holes in the bottom
of the BUC 202 with the holes in an Extron
rack shelf (1). Fasten the BUC 202 to the
shelf with two 4-40 x 3/16 inch screws as
shown on the right.
2. Bolt the rack shelf to the rack (2).
Under-Furniture Mounting
NOTE:
The ZipClip is shipped with
a set of four wood screws.
1. Attach the ZipClip to the furniture
using two or more wood screws as
shown on the right (1). Make sure the clip
is oriented with the appropriate side facing
the mounting surface and with the tab
accessible from the front of the furniture.
2. Insert the BUC 202 into the ZipClip as
described previously and press to snap it
into place (2).
68-2351-50
Rev. A 03 14
100- 240 V 50 /60 Hz
0.2 A MA X
TRI M
1 2
1
2 TRI M
OUT PUT S BU C 2 02
15 18 0 21 3 6 9 12
-15-18 -2 1 -3 -6 -9 -12
15 18 0 21 3 6 9 12
-15-18 -21
-3 -6 -9 -12
1 2 INP UT S
BU C 202
BUC
202
Side of Rack
ZipClip 200
Back of
Rack
Inside of Rack
BUC 202
(2) 4-40 x 3/16"
Screws
RSB 123
Rack Shelf
Rack Mounted
1
2
BUC 202
ZipClip 200
1
2
2
100 -24 0V 50 /60 Hz
0.2A M AX
1
1
2 TRIM
OUT PUT S BU C 20 2
15 18
0
21
36 9 12
-15 -18- 21
-3 -6 -9 -12
15 18
0
21
36 9 12
-15 -18- 21
-3 -6 -9 -12
1 2 INP UTS Furniture Mounted
Extron Headquarters
+1.800.633.9876 (Inside USA/Canada Only) Extron Asia
+65.6383.4400 Extron China
+86.21.3760.1568 Extron Korea
+82.2.3444.1571
Extron Europe
+31.33.453.4040 Extron Japan
+81.3.3511.7655 Extron Middle East
+971.4.299.1800 Extron India
+91.80.3055.3777
© 2014 Extron Electronics All rights reserved. www.extron.com