Extron Electronics AVT 200HD User Guide - Manual (Page 68)

AVT 200HD Tuner • Remote Configuration and Control 62
Command
ASCII Command
(Host to Tuner)
Response
(Tuner to Host)
Additional Description
IP Setup Commands (continued)
View broadcast mode
E EB } Bmd X9% , X5$]
Set broadcast port and MAC
address EX4@ * X10# * X10$ PB } Bpt X4@ * X5(] X4@ = UDP outgoing port
X10# * X10$ = MAC address for
UDP unicast transmissions
Set event target IP address EX7$ , X5$ ID } Edi X7$ * X5$ * X4@] X7$ = event number (event must
be running).
X7$ = 0–99.
Set event target TCP port EX7$ , X4@ ID } Edi X7$ * X5$ * X4@]
Set event target IP address EX7$ ID } X5$ * X4@]
Password and security settings
Set administrator password
24 EX7@ CA } Ipa• X7(] Set administrator access
password
X7@ .
X7@ = 4 to 12 alphanumeric
characters. The password is case
sensitive. Special characters
(spaces or symbols) are not
allowed.
X7( = hidden password, shown
as four asterisks (****) if a
password exists; empty if not.
View administrator password 24 E CA } X7(]
Reset (clear) administrator 24
password
E •CA } Ipa• ] Clear or remove all passwords
(administrator and user).
Set user password 14,34 EX7@ CU } Ipu• X7(] Set user access password X7@ .
X7@ = 4 to 12 alphanumeric
characters. The password is case
sensitive. Special characters
(spaces or symbols) are not
allowed.
X7( = hidden password, shown
as four asterisks (****) if a
password exists; empty if not.
NOTE: A user password cannot be assigned if an administrator password does not exist. Entering a password when the
AVT has not been configured yields an E14 error response from the tuner. If the administrator password is cleared
(removed), the user password is removed also.
View user password E CU } X7(]
Reset (clear) user password E •CU } Ipu• ] Clear or remove the user
password.
Query session security level E CK } X8*]
In verbose mode:
Pvl
X8*]
Remap Port Destinations
NOTES: • Duplicate port number assignment are pnot permitted (for example, the Telnet and web mapping cannot be the
same. An E13 (invalid parameter) error code results.
• Remapping of the port number other than to reset to defaults 80 or 23, or to disable by resetting it to 0 can be
done only to ports 1024 or higher.
Set Telnet port map 24 EX4@ MT } Pmt X4@] X4@ = Telnet port number
Reset Telnet port map 24 E 23MT } Pmt00032 ]
Disable Telnet port E 0MT } Pmt00000 ]
View Telnet port mapping E MT } X4@]