Extron Electronics AVTRac End Ramp and Cable Pass-Through Kits User Manual
Extron, Avtrac, Cable pass-through kit
Extron
®
AVTrac
®
Cable Pass-Through Kit
The AVTrac Cable Pass-Through kit is a one-piece pass through transitional ramp that abuts a
hollow table leg, desk or lectern. Cables carried by the AVTrac pass through a hole in the furniture
and run on to connect to the appropriate device.
NOTE:
The AVTrac Connectivity Box is not required as cables are routed through the metal
track and directly into the furniture.
Full details about installing the AVTrac system are
provided in the AVTrac User Guide, available at
1.
Mark where the end ramp abuts the
furniture.
2.
Drill a hole into the furniture. The hole
must be large enough for the cables to
pass through easily, but small enough to be
concealed by the end ramp kit.
3.
Pre-drill 5/32 inches diameter holes in the
track and ramps.
4.
Pre-drill holes 1.5 inches deep in the concrete
floor, using the drill bit provided.
5.
Secure the track to the floor, using the provided masonry screws.
6.
Run power and A/V cables from the wall, along the track and through the furniture. Connect
the cables as required.
7.
Snap the cover track in place and cover the ramps with carpet to finish.
Rubber Strip (optional)
Aluminum
Cover Track
Side Ramp
Hole Drilled in Furniture
Cable
Pass-Through
Ramp
68-1795-01 B
10 10
Extron
®
AVTrac
®
End Ramp Kit
© 2010 Extron Electronics. All rights reserved.
End transition ramps are already
provided with all AVTrac system kits.
The ramps are now available as a
separate kit (part number 70-714-01)
for situations where only end ramps
are required to complete an existing
AVTrac installation.
Install the AVTrac system as described
in the AVTrac User Guide, which is
available at
To add the end ramps to the system:
1.
Place the end ramps in position abutting the end of
the track.
2.
Pre-drill 5/32 inches diameter holes through the ramp.
3.
Drill holes 1.5 inches deep into the floor, using the drill bit
provided.
4.
Secure the ramps with the masonry screws provided.
5.
Cover the ramps with carpet to finish.
End Ramps