Extron Electronics AKM UK Series User Manual

Akm uk series installation guide, Preparing the installation site, 1akm uk series • installation guide

Advertising
background image

1

AKM UK Series • Installation Guide

AKM UK Series Installation Guide

This guide provides installation instructions for the following Extron AKM UK
Series faceplates, designed for use with the Ackermann CRX 4090 or CRX 4120
floor box:

RGB 468xi AKM UK

, which

consists of an RGB 460xi Series
interface and space for three
single-size AAPs.
Part number: 60-626-01.

Extender AKM UK AAP

, which

consists of an Extender Series
VGA line driver with audio and
space for three single-size AAPs.
Part number: 60-627-01.

AAP 106 AKM UK

, which

consists of space for six single-size
AAPs with no electronics.
Part number: 60-628-01.

AKM UK Blank

, which has no

electronics or AAP openings and
is used to cover any openings left
after installing other AKM UK
Series faceplates in the floor box.
Part number: 60-629-01.

CAUTION

To ensure correct equipment placement and operation, this installation
procedure should be performed by authorized personnel only.

Preparing the Installation Site

Take the following steps to prepare the installation site:

1.

Determine the electronics, AAPs, and cabling required for this installation.
The Ackermann CRX 4090/CRX 4120 floor box can accommodate four AKM
UK faceplates.

2.

Turn off all equipment. Make sure the computer, interface, and output devices
(e.g., projector, monitor, etc.) are all turned off and disconnected from the
power source.

3.

Select an installation site that allows cable runs without interference. Allow
enough depth for both the floor box and the cables.

4.

Install the floor box in accordance with the documentation that accompanied
the floor box.

5.

Route all cables required for the installation through the floor box punch-out
holes.

CAUTION

Exposed cable shields (braids or foil) are potential sources of short circuits.
To prevent short circuits, shields should be trimmed back or insulated with
heat shrink. Both braided and foil shields should be connected to an
equipment ground at the other end of the cable.

68-904-01 Rev. A

Printed in the USA

11 03

RGB 468xi AKM UK

H. SHIFT

MIN/MAX

PC AUDIO

PC INPUT

MONITOR

NO

MONITOR

MONITOR

EXTENDER AKM UK AAP

AUDIO

PC INPUT

AAP 106 AKM UK

Advertising