Extron Electronics AVTrac Raceway Transition User Manual
Extron, Avtrac, Raceway transition • user guide
Extron
®
AVTrac
®
Raceway Transition • User Guide
The AVTrac Raceway Transition provides a clean and efficient transition from the
floor‑mounted AVTrac to a wall‑mounted raceway (not provided).
For complete information about installing the AVTrac system, see the AVTrac User Guide,
The two available versions are:
z
Compatible with the Wiremold 4000 series (shown in the illustrations)
or
z
Compatible with most Euro Channel trunk systems. The Euro Channel kit does not have
the rabbit ears.
NOTE: The Euro Channel version fits wall‑mounted raceways with dimensions
90 ‑ 120 mm (3.5 ‑ 4.7 inches) wide x 50 ‑ 65 mm (2.0 ‑ 2.6 inches) deep.
Install either model as follows:
1.
Install the AVTrac so that it runs up to and meets
the foot of the wall. Do not fix the cover track to
the base track or cover the ramps with carpet at
this time.
2.
Remove the two screws holding the front plate in
position and lift it away from the transition unit
(see the figure at right).
3.
Place the transition unit on top of the base track
of the AVTrac and against the wall. Mark the
positions of at least two mounting holes in the
base.
NOTE: If only two screws are used to secure the raceway transition, they must be in
diagonally opposite corners of the base.
4.
Drill holes, 5/32 inches (0.4
cm) diameter and 1 1/2 inches
(3.8 cm) deep, through the
AVTrac and into the concrete
floor.
5.
Using the masonry screws
provided, secure the raceway
transition unit to the floor.
6.
Install the wall‑mounted
raceway following the
instructions provided by the
manufacturer.
The Wiremold version of the
kit has rabbit ears on the sides,
which fit inside the raceway.
There are no rabbit ears on
the Euro Channel version and
the wall‑mounted raceway is
secured to the wall so that it
sits on top of the transition
unit.
Front Plate
Screws (2)
AVTrac
Raceway
Transition
Mounting
Holes
Wall-mounted
Raceway
(2) Masonry
Screws
Rabbit Ear
(Wiremold kit only)
AVTrac Raceway (base)