Extron Electronics Cable Cubby Single Space AAP Bracket Kit - Manual

Extron USA - West
Headquarters
+800.633.9876
Inside USA / Canada Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA / Canada Only
+1.919.863.1794
+1.919.863.1797 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664 FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656 FAX
Extron China
+400.883.1568
Inside China Only
+86.21.3760.1568
+86.21.3760.1566 FAX
Extron Middle East
+971.4.2991800
+971.4.2991880 FAX
68-1799-01
Rev. A
09 09
Cable Cubby Power Module AAP Single Space Bracket Kit
Install the single space bracket as follows:
1. If necessary, remove the Cable Cubby from the installed location. Refer to the
Cable Cubby User’s Manual.
2. If necessary, remove the power module from the Cable Cubby. Refer to the
Cable Cubby User’s Manual.
W
Disconnect power from the power module before removing
the side panel.
3. Remove and discard the four screws that secure
the side panel to the power module and the side
panel itself. See the drawing at right.
4. Using the four screws included in the kit, install the
single space bracket kit where the side panel had
been. See the drawing at right.
5. If applicable, reinstall the power module in the
Cable Cubby and reinstall the Cable Cubby.
Power
Module
Philips Head
Screws (4)
Remove Side
Panel