Extron Electronics CPM112R User Manual
Cpm112r installation instructions, Cpm112r installation instructions (cont’d)
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Daisan DMJ Building 6F
3-9-1 Kudan Minami
Chiyoda-ku, Tokyo 102-0074 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
www.extron.com
CPM112R Installation Instructions
The Extron CPM112R is a full rack width, 1U high rack mounting panel that allows the
installation of multiple MAAPs into an equipment rack as a single unit. The CPM112R
has 6 double space MAAP openings that can be populated with up to 12 single space or
6 double space MAAPs.
To attach MAAPs to the CPM112R panel and install it into a rack:
1
. Cable the rear of the MAAPs to be installed before attaching them to the panel.
If applicable, refer to the cabling information in the documentation for the MAAPs.
2
. Use the mounting screws provided with the MAAPs to secure them to the panel. See
the figure on the reverse side of this card. If desired, fill unused openings with blank
MAAPs.
3.
For strain relief, use tie wraps to secure the cables to the panel’s cable management
rail.
4
. Hold the panel (with the MAAPs attached) against the rack, aligning the holes in the
panel with those in the rack.
5
. Secure the panel to the rack using the supplied machine screws. See the figure on the
reverse side of this card.
68-883-01
Rev. A
10 03
Printed in the USA
CPM 112R
#10-32 Screw
w/ Nylon Captive
Cap Washer
DAV101CM
VG
A L
ine
D
riv
er
Vid
eo
In
pu
t
Po
we
r
SH
AR
P
(4) #4-40
Screws
CPM112R Installation Instructions (Cont’d)