Extron Electronics DTP DVI 230 Setup Guide - Manual

DTP DVI 230 • Setup Guide
This guide provides quick start instructions for an experienced installer to set up and operate the
Extron DTP DVI 230 digital video extender. The DTP DVI 230 transmitter and receiver pair can extend
a DVI signal up to 230 feet (70 m).
NOTE: For full installation and operation details, see the DTP DVI 230 User Guide, available at
www.extron.com ).
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the Tx and Rx units as required.
DTP DVI 230 Tx
DTP DVI 230 Rx
L R
OUTPUTS
DVI-D
AUDIO
DTP DVI 230 Rx
INPUTS LOCAL OUTPUT
AUDIO DVI-D
DTP DVI 230 Tx Rx G Tx
RS-232 IR
Rx Tx
POWER
12V
0.8 A MAX
SIG LINK
DTP OUT
OVER DTP
Rx G Tx
RS-232 IR
Rx Tx
POWER
12V
0.8 A MAX
SIG LINK
DTP IN
OVER DTP
LOCAL SHARE
REMOTE
1 2
ON
DDC ROUTE
Front Rear
4 8
8
1 5 2 3
Front Rear
4 7 6 5
Step 2 — Connections
a DVI Input connector (Tx) — Connect a DVI cable between this port and the DVI output port of the digital video source.
b Local Output connector (Tx) — If desired, connect a DVI monitor for local monitoring of the input digital image.
c Audio input (Tx) — Connect an unbalanced stereo audio source to this 3.5 mm mini stereo jack for an analog audio input.
d RS-232 and IR connectors (both units) — To pass serial or infrared data or control
signals, such as serial control of a projector, connect the master device to the transmitter
and the slave device to the receiver via the RS-232 and IR captive screw connector on both
units.
e DTP RJ-45 connectors (both units) — Connect transmitter DTP Out to receiver DTP In.
Extron recommends that you terminate both cable ends in accordance with the following
specifications, at a minimum:
z TIA/EIA T 568 B z CAT 6A, shielded
z 24 AWG, solid conductor
ATTENTION: Do not connect these devices to a computer data or telecommunications
network.
Sig(nal) LED (both units) — This LED lights when the unit is receiving a TMDS clock signal on the
DVI input (transmitter) or any valid signal on the DTP In connector (receiver).
Link LED (both units) — This LED lights when a valid link is established between the units on the
DTP cable.
f DVI Output connector (Rx) — Connect a display with a DVI input for display of the transmitted direct digital image.
5
Pin
1
2
3
6
7
8
4
Wire color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Blue
TIA/EIA T
568 B
TP Wires
12345678
Pins:
Ground
Receive pin on connected unit
Transmit pin on connected unit
Connected RS-232
and IR Device Pins
Tx/Rx
Pins
Receive pin on connected unit
Transmit pin on connected unit
Rx
G
Tx RS-232
I
R Rx
Tx