Installing the program, Installing and starting the matrix, Switchers control program – Extron Electronics DXP DVI Pro Setup Guide User Manual
Page 39: Installing and, Starting the matrix switchers control program, For details on
33
DXP DVI Pro and DXP HDMI Series • Remote Control
Installing and Starting the Matrix Switchers Control
Program
Another way to operate the switcher is via the Matrix Switchers
Control Program. This program is contained on the Extron Software
Products DVD (included with the switcher). Run this program on a PC
connected to either of the switcher serial ports or the Ethernet port.
See "
", "
" and
"
" in the "Installation" section for connection
information. The program must be installed on a computer; it cannot
be run from the software disc.
NOTE: For details on operating the program, see the
DXP DVI Pro and DXP HDMI User Guide, “Matrix
Software” section, and to the control program help file.
Installing the Program
1.
Insert the DVD into the drive. The disc should start automatically.
The Extron software DVD window appears.
Figure 20.
Software Button on the Software DVD Window
NOTE: If the DVD does not self-start, run Launch.exe from the
disc.
2.
Click the Software tab.