Sis command and response table – Extron Electronics DVS 304 Series User Guide User Manual
Page 42
SIS Command and Response Table
Command
ASCII Command
(host to scaler)
Response
(scaler to host)
Additional Description
Input selection
Video and audio
X7!!
In
X7!
• All]
Select video and audio from input
X7!
.
Video
X7!&
In
X7!
• RGB]
Select video from input source
X7!
.
Audio
X7!
$
In
X7!
• Aud]
Select audio from input source
X7!.
Input video type (input 2 and input 4)
Set video type
X7@
*
X7#
\
X7@
Typ
X7#
]
Set input
X7@
to format
X7#
.
View video type
X7@
\
X7#
]
View video type of input
X7@
.
Select SDI input number (SDI models only)
Set video type
X7!
* 9 \
X7!
Typ 9]
Set input
X7!
to SDI.
View video type
X7!
\
X7#
]
View video type of input
X7!
.
Horizontal start
Specify a value
X7$
)
Hst
X7$
]
Set horizontal location of first active pixel in active
window.
Increment value
+ )
Hst
X7$
]
Increment to a higher horizontal start position.
Decrement value
– )
Hst
X7$
]
Decrement to a lower horizontal start position.
View
)
X7$
]
Show horizontal location of first active pixel in
active window.
Vertical start
Specify a value
X7%
(
Vst
X7%
]
Set vertical location of first active line in active
window.
Increment value
+ (
Vst
X7%
]
Increment to a higher vertical start position.
Decrement value
– (
Vst
X7%
]
Decrement to a lower vertical start position.
View
(
X7%
]
Show vertical location of first active line in active
window.
Pixel phase (available only for RGB and YUVp/HDTV input signals)
Specify a value
X7^
U
Phs
X7^
]
Adjust the pixel phase to specified value.
Increment value
+ U
Phs
X7^
]
Increase the pixel phase.
Decrement value
– U
Phs
X7^
]
Decrease the pixel phase.
View
U
X7^
]
Show the pixel phase.
Total pixels (available only for RGB and YUVp/HDTV input signals)
Specify a value
11*
X7&
#
Tpx
X7&
]
Adjust the total pixels to specific value.
Increment value
+11 #
Tpx
X7&
]
Increase the total pixels.
Decrement value
- 11 #
Tpx
X7&
]
Decrease the total pixels.
View
11 #
X7&
]
Show the total pixels.
NOTE:
X7! = Input selection
1 to 4
X7@ = Input selection
2 or 4
X7# = Input video format
1 to 9 (see page 35)
X7$ = H start
0 to 127 for video, 0 to 255 for RGB and YUVp/HDTV
X7% = V start
0 to 93 for video inputs; 0 to 255 for RGB and YUVp/HDTV inputs.
X7^ = Pixel phase:
1 to 31
X7& = Total pixels
+/- 512 of the default value
DVS 304 Series • SIS Communication and Control
37