Extron Electronics DVS 605 User Guide - Manual (Page 44)

X2! = Analog output polarity:
0 = H-/V- (default)
1 = H-/V+
2 = H+/V-
3 = H+/V+
X2@ = Analog output sync format:
0 = RGBHV (default)
1 = RGBS
2 = RGsB
3 = Y, R-Y, B-Y bi-level
4 = Y, R-Y, B-Y tri-level
X2# = User presets or PIP presets — 1 to 16
X2$ = Input presets — 1 to 128
X2% = On-screen menu time-out or screen saver sync timeout, (default = 3 seconds)/output sync
time-out (default = 501 - never)
0 = OSD is never displayed/output sync is instantly disabled with no active input
1 to 500 in 1 second increments,
501 = OSD never times out, output sync is never disabled
X2^ = Executive mode status:
0 = Off/disable, (default)
1 = Exec mode 1 — Complete front panel lockout
2 = Exec mode 2 — Partial front panel lockout (only input selection, Auto-Image, and
PIP/Swap are still available)
X2& = PIP window input selection: 0 to 4 (0 = off). (Input 5 is not available for PIP mode.)
X2* = Overscan (applied to SMPTE [NTSC, PAL, 480p, 576p, 720p, 1080i, 1080p] input rates):
0 = 0.0% (default for RGB/HDMI),
1 = 2.5% (default for YUV, RGBcvS, S-video, composite)
X2( = Aspect ratio:
1 = Fill: each input rate will automatically fill the entire output raster (default)
2 = Follow: each input rate will be displayed with its native aspect ratio
X3) = Screen saver mode:
1 = Black screen (default)
2 = Blue screen with OSD text
X3! = Video mute:
0 = off/disable
1 = on/enable (mute to black)
2 = mute output sync and video
X3@ = Auto-Image threshold value: 0 (black) though 100 (white), default = 25
X3# = HDCP status (valid only on HDMI/DVI outputs):
0 = No sink or source detected
1 = Sink or source detected with HDCP
2 = Sink or source detected but no HDCP is present
X3% = Video switching duration:
from 2 (0.2 sec) to 50 (5.0 sec). Default value is 3 or 0.3 sec
DVS 605 • SIS Communication and Control 38