Extron Electronics DVI 110 Installation - Manual

The Extron
®
DVI 110 Signal Regenerator maximizes the
quality of a digital signal. The DVI 110 should be installed
at the beginning of a cable run, near the DVI source. The
cable from the source to the DVI 110 should be no longer
than 15 feet (4.5 m). To install the regenerator:
1. Mount the DVI 110 (optional).
2. Connect a DVI input device to the input connector on the DVI 110 rear panel.
NOTE:: Alternatively, the DVI 110 can be placed in the middle of a signal path to
improve a poor quality signal.
3. Connect a display device to the output connector on the DVI 110 front panel.
4. (Optional) To maximize signal quality, connect an Extron DVI 101 Cable Equalizer to
the output cable, immediately preceding the display device in the cable run. The
cable between the DVI 101 and the display should be no more than 15 feet (4.5 m).
NOTE: For best results when you are using a DVI 101, the total cable length
from the DVI 110 to the display should be 200 feet (61 m) or less.
5. Connect the provided 12 V, LPS, Class 2, 1 A external power supply
to the 2-pole captive screw connector on the DVI 110 rear panel.
DVI 110 Installation Guide
Extron Electronics, Anaheim, CA
www.extron.com
DVI 110 Installation Guide, cont’d
Application Diagram Example
DVI-D OUTPUT
POWER 12V 0.4A MA
X
DVI 101
DVI-D OUTPUT
Projector
Extron
DVI 101
DVI Equalizer
Extron
DVI 110
DVI Regenerator
Extron
DVID SL Pro Series
200' (61 m) max.
Laptop with
DVI Output
Short DVI Patch Cable
15' (4.5 m) max.
Short DVI Patch Cable
15' (4.5 m) max.
Status LED
The Status LED on the front
panel lights to indicate the
following:
Amber – Unit receiving power
Green – Input signal present
DVI-D OUTPUT
POWER
12V
0.4A MAX
68-1974-50
Rev A
11 10