Extron Electronics FF 220T User Guide - Manual (Page 8)

Installing the Speaker
1. Power down — Power down all attached devices before proceeding.
2. Remove the suspended ceiling tile — Remove the square ceiling tile where the
FF 220T will be installed as shown below. If the ceiling has rectangular tiles, cut the tile
in half.
3. Remove the terminal cover plate — Loosen (do not remove) the two screws on the
top terminal cover plate and remove the cover plate as shown below.
Loosen but do not remove
the 2 transformer cover plate
screws in the 2 keyhole slots.
Transformer Cover Plate
Figure 2. Removing the Terminal Cover Plate
Rectangular Ceiling Tile
Draw Line At
Halfway Point
Cut Material
T-rail
Crosspiece
(supplied)
Ceiling Tile
FF 220T User Guide • Installation 4