Extron Electronics EMOTIA Jr. 800 - Manual (Page 2)

1 Extron • E MOTIA J R . 800 • User’s Guide
Installation
Extron • E MOTIA J R . 800 • User’s Guide 2
E E MOTIA MOTIA JJ R R .. 800 800 Extron Extron
COMPUTER TO TV SCAN CONVERTER
FREEZE FLICKER
CONTROL POWER
Features
Extron’s E MOTIA J R . 800™ converts VGA sources (31.5 - 48 kHz)
with resolutions up to 800 x 600 into NTSC or PAL and S-Video
compatible outputs. The E
MOTIA J R . 800 requires no software.
Simply connect it from the PC to the desired display (LCD
Projector, CRT Projector, consumer TV, VCR or compatible video
display).
Installation
1. Turn the PC and its monitor Off.
2. Connect the input cable’s (26-112-15) male end to the PC and the
female end to Emotia Jr. 800’s 15-pin HD, VGA Input connector.
3. Use the PC monitor’s cable to connect to Emotia Jr. 800’ S VGA
Output.
4. Connect the desired output cable (S-VHS or RCA) to the input
connector of the display device.
5. Turn PC and PC monitor power On.
6. Plug the power supply into a service outlet and plug its cable to
Emotia Jr. 800’ S connector marked “Power 9v, 1A”.
7. Use Emotia Jr. 800’ S and controls to center the image on the
screen.
8. Set the front panel “Underscan/Overscan” switch to select the
desired
image size.
Parts included with the
Emotia Jr. 800 are:
VGA (male-female) 6’
Input cable –26-112-15
(PC to Emotia Jr. 800)
Composite (RCA), 6’
Output cable –26-345-01
(Emotia Jr. 800 to Composite
Video device)
S-Video (S-VHS) , 6’
Output cable –26-316-02
(Emotia Jr. 800 to S-Video
device)
External Power Supply,
9 VDC –28-023-01
(Emotia Jr. 800 to AC power
source)
Tweaker (small screwdriver)
Front Panel Features
Freeze - Press this button to capture a still image of a scan-
converted computer screen. The LED indicates when Freeze
mode is active.
Flicker Control Switch – 3 positions:
Up = Normal Mode
Mid-position = Flicker Reduction Mode
Down = Non-Interlaced Mode
Rear Panel Features
S-Video - Use this output for devices that use S-Video or S-VHS.
This is the highest quality recordable video out of the E
MOTIA Jr.
800.
Video = NTSC or PAL (depending on version) - An RCA
connector provides either NTSC or PAL composite video.
Underscan/Overscan - This switch either underscans or
overscans the displayed image on the screen. (Use this switch in
the underscan position when displaying text.)
Picture – These two controls are:
Vertical Center ( ) (shifts the image up or down on the screen).
Horizontal Center (
) (shifts the image left or right on the screen).
FREEZE
UNDER
OVER
FLICKER
CONTROL
R
PICTURE
S-VIDEO
VIDEO
POWER
INPUT
COMPUTER S-VIDEO MONITOR VIDEO
UNDER
OVER
Extron Extron
OUTPUT
PICTURE