Extron Electronics Ferrite Bead Kit - Manual

Ferrite Bead Kit • Installation Guide
After installation, the Extron
®
DFX 100 and HFX 100 series extenders should provide clear
video output signals. If there are problems with EMI interference, place the provided ferrite bead
around the cable of the receiver (DFX 100 Rx or HFX 100 Rx) by following these instructions:
1. If necessary, release the catch on the
ferrite bead and open it.
2. Place the bead around the video
output cable. It should be positioned
2.0 inches (5.1 cm) from the rear panel
of the receiver.
3. Close the bead. When the catch
closes, the bead clamps securely
around the cable.
© 2013 Extron Electronics. All rights reserved. www.extron.com
Extron USA - West -
Headquarters
+800.633.9876
Inside USA/Canada Only
+1.714.491.1500
+1.714.491.1517 FAX
Extron USA - East
+800.633.9876
Inside USA/Canada
Only
+1.919.850.1000
+1.919.850.1001 FAX
Extron Europe
+800.3987.6673
Inside Europe Only
+31.33.453.4040
+31.33.453.4050 FAX
Extron Asia
+800.7339.8766
Inside Asia Only
+65.6383.4400
+65.6383.4664
FAX
Extron Japan
+81.3.3511.7655
+81.3.3511.7656
FAX
Extron China
+4000.398766
Inside China Only
+86.21.3760.1568
+86.21.3760.1566
FAX
Extron Middle
East
+971.4.299.1800
+971.4.299.1880 FAX
68-2375-01
Rev. A
03 13
2.0"
(5.1 cm)
Video Cable
Ferrite Bead
INPUT