Extron Electronics EWB 710 - Manual

IMPOR
TANT
:
Refer to www
.extron.com for
the complete TLP 710 Series
user guide befor
e connecting
the pr
oduct to the power sour
ce.
EWB 710 • Installation Guide
Overview
The Extron EWB 710 wall box is an
optional accessory for mounting
the TLP 710MV touchpanel onto
the surface of various wall types
(such as drywall, wood, or masonry)
where it is not possible to embed
the touchpanel in the wall. The
EWB 710 has knockouts that accept
raceways or conduit for running
cables over the surface of the wall to
the touchpanel.
Planning
The following items are required for
installation, but are not supplied:
z Extron TLP 710MV
z Four mounting screws (Extron
recommends a minimum length
of 1 inch)
z Power drill
z Drill bit that is appropriate for
wall type
z Conduit or surface raceway to carry cables
z Screwdriver
z Level
Mounting Suggestions for Different Wall Types
Choose a type of screw or bolt that is appropriate for the wall on which you are
mounting the EWB 710 (see table below). The mounting holes in the back of the EWB 710
accommodate screws up to ¼ inch in diameter.
Wall Type Fasteners Min. Size
Fastener
Quantity Drill Bit
Size
Notes
Drywall Toggle bolts 3/16 inch 4 1/2 inch Min. 3/8 inch
wall thickness
Wood
(solid wall
or stud) Wood screws #10 screw
with a
washer 4 1/16 inch
wood bit Min. 3/8 inch
wall thickness
Masonry Masonry
screws 1/4 inch 4 3/16 inch
masonry bit Do not mount to
masonry joints
Extron
EWB 710
Wall Box
Extron
TLP 710MV
Extron
TLP 710MV
Faceplate