Extron Electronics EWB Series External Wall Boxes User Manual
Extron Electronics Hardware
1
EWB Series External Wall Boxes • Installation Guide
The Extron EWB Series External Wall Boxes allow a variety of Extron products to be mounted to the surface of an interior
wall. The 2.5 inch (6.4 cm) depth accomodates an Extron product and cabling. This guide provides information for a
qualified, experienced installer to install an EWB wall box.
EWB External Wall Box Models
EWB 104
4-gang EWB
EWB 105
5-gang EWB
EWB 103
3-gang EWB
EWB 102
2-gang EWB
EWB 101
1-gang EWB
Recommended Fasteners
Choose the appropriate type of screw or bolt for the wall (see table below). The mounting holes in the back of the EWB
accommodate screws up to ¼ inch in diameter.
Wall Type
Fasteners
Min. Size Fastener Quantity
Drill Bit Size
Notes
Drywall
Toggle bolts
3/16 inch
At least 4
1/2 inch
Min. 3/8 inch wall thickness
Solid wood
Wood screws
#10 with a washer
At least 4
Not required
Min. 3/8 inch wall thickness
Masonry
Masonry screws 1/4 inch
At least 4
3/16 inch masonry bit
Do not mount to masonry joints.
Grounding
The rear inside panel has a PEM
®
#6‑32 insert for grounding; a grounding screw is included with each EWB.
Mounting the EWB
NOTES: This unit must be installed in accordance with the National Electrical Code and with all local codes.
z
z
Ensure that the installation meets the local and state regulatory requirements, including building,
electrical, and safety codes, and UL and ADA accessibility requirements.
z
z
Ensure that there are no utility cables or pipes at the intended location that might be damaged or cause
injury when installing the wall box.
The EWB can be mounted on any interior wall type. Knockouts allow for conduit or raceways to be run from the top,
bottom, or back of the box. Install the cables into the wall or conduits before mounting the EWB wall
box or installing any devices in the EWB. The installation instructions apply to all models.
Model
Part Number
EWB 101
(black, white)
60‑1161‑02, ‑03
EWB 102
(black, white)
60‑1162‑02, ‑03
EWB 103
(black, white)
60‑1163‑02, ‑03
EWB 104
(black, white)
60‑1164‑02, ‑03
EWB 105
(black, white)
60‑1165‑02, ‑03
Surface Raceway Knockouts
Size
Dimensions
Quantity
per EWB
Small 0.9” H x 0.75” W
(2.3 cm H x 1.9 cm W)
2
Large 0.95" H x 2.0" W
(2.4 cm H x 5.1 cm W)
2
Mounting
Screws (4)
4
Installing the EWB Onto a Wall
1.
If mounting to standard wood wall studs, locate the center of the studs.
2.
Place the EWB against the wall in a suitable location. Use a level to ensure the box is
horizontal, and mark the position of the four holes.
3.
If required, drill four holes into the wall.
4.
Insert four screws (see the table above) and attach the EWB to the wall.
Contents
Installing the EWB Onto a Wall ...........................................1
Attaching the EWB to an Existing In-wall Junction Box .......2