Extron Electronics IR 201 - Manual

User’s Guide
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Daisan DMJ Building 6F
3-9-1 Kudan Minami
Chiyoda-ku, Tokyo 102-0074 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
www.extron.com
© 2002 Extron Electronics. All rights reserved.
IR 101 Universal Remote
IR 201 SYS 4/8/10/AV Remote
68-200-01 Rev. E
Printed in the USA
04 02
Infrared Remote Controls
1 . Power down the switcher.
2 . Connect the IR 101 adapter’s 25-pin plug to the Remote
connector on the switcher’s rear panel.
3 . Plug the IR detector’s RJ-11 male connector into the IR 101
adapter’s rear panel RJ-11 female connector.
4 . Position the IR detector for the best line of sight of the infrared
light from the IR 101 hand-held remote controller.
5 . Power up the switcher.
IR 201 (Part #70-141-03) installation
Install the IR 201 Sys 4/8/10/AV remote control system (figure 3) as
follows:
INPUTS
L R L R L R L R L R L R 1 2 3 4 5 6 L R A B L R
OUTPUTS
SW 6 SA MX
IR-201 remote control adapter IR-201 remote control
RS-232
T-connector
3 foot cable
6 foot
cable
IR detector
IR-201
RS-232
control
Power
supply
Figure 3 — Typical IR 201 application
1 . Power down the switcher.
2 . Connect the IR 201 adapter’s 9-pin T-connector to the RS-232
connector on the switcher’s rear panel. If desired, connect a
host device, such as a computer or touch panel control, to the
switcher via this 9-pin D connector for serial RS-232 control.
3 . Plug the IR detector’s RJ-11 male connector into the IR 201
adapter’s rear panel RJ-11 female connector.
4 . Connect the external power supply to the IR 201 adapter. Plug a
standard IEC power cord into the power supply to connect the
adapter to a 100 to 250VAC, 50 Hz or 60 Hz power source.
5 . Position the IR detector for the best line of sight of the infrared
light from the IR 201 hand-held remote controller.
6 . Power up the switcher.