Extron Electronics IN1502 User Guide - Manual (Page 23)

2-11 IN1502 • Installation and Operation
Advanced Configuration
The following flowchart provides an overview of the Advanced Configuration
submenus and the options for each setting.
ADVANCED
CONFIG
NEXT
BLUEMODE
<OFF> ON
NEXT
AUTOSW
<OFF> ON
Display blue and sync only
• On
• Off (default)
Autoswitch mode
• On
• Off (default)
2:2 PLDN
<OFF> ON
PAL film mode (2:2 pulldown detection)
• On
• Off (default)
NEXT
NEXT NEXT
OUTPUT
CONFIG
PICTURE
CONTROL
MENU
MENU
MENU
Default
Cycle
T BLNK B
000 000
Top and bottom blanking
• Top blanking ranges from 000 (default)
to 127
• Bottom blanking ranges from 000 (default)
to 127
Top and bottom blanking
To remove noise or extraneous material, such as closed captioning, remove scan
lines at either the top or bottom of the screen. Rotate the horizontal Adjust (
)
knob to adjust the top blanking from 0 to 127 lines. The default is 0. Rotate the
vertical Adjust ( ) knob to adjust the bottom blanking from 0 to 127 lines. The
default is 0.
Blue mode
To aid in setup of the scaler’s color and tint, the Blue mode can be set from this
submenu to “On” so that only sync and blue video signals are passed to the
display.
Use either the horizontal Adjust ( ) or vertical Adjust ( ) knob to specify this
mode. The default is “Off”.
Autoswitch (Autosw) mode
The Autoswitch mode causes the highest numbered input that has a signal
present to be automatically selected. For example, if both Inputs 1 and 2 have
active input signals, Input 2 is selected.
From this submenu, use either the horizontal Adjust ( ) or vertical Adjust ( )
knob to specify this mode as “On” or “Off”. The default is “Off”.