Extron Electronics IN3254 Setup Guide - Manual

Setup Guide — IN3254
This guide provides basic instructions for an
experienced installer to set up and operate the
Extron ® IN3254 Distribution Amplifier (DA).
C Installation and service must be performed
by authorized personnel only.
Step 1 — Turn off the DA and input/output devices
Turn the input and output devices off and unplug their power cords. Verify that the DA is
disconnected from the power source before proceeding.
Step 2 — Attach input cables
Connect an RGBHV, RGBS, RGsB, RsGsBs, component video, S-video, or composite video
device to these BNC connectors (
c
). See figure 1 for information on how to cable the
BNC connectors.
Step 3 — Attach output cables
Connect up to four RGBHV, RGBS, RGsB, RsGsBs, component video, S-video, high
resolution monochrome video, or composite video output devices, such as projectors or
monitors, to these BNC connectors (
d
). See figure 1 for information on how to cable the
BNC connectors.
Step 4 — Power on DA, input/output devices, and check for picture
Plug the external power supply cord into the power connector (
a
). When power is
applied to the unit, the front and rear panel LEDs (
b
) light.
Connect the power cords and turn on the input and output devices. The picture should
appear on the video displays.
N The output signal(s) must match the input signal. If the picture does not appear, check
that the BNCs for the output(s) and input are connected with an identical signal.
Step 5 — Adjust video gain and sync level
Use the sync and gain DIP switches (
e
) to select either high or low video gain and sync
level. Adjust video gain while viewing the displayed image to set the level that provides
the best picture quality.
Figure 1 – IN3254 connectors/controls and connection diagram
R
G
B
H
V
RGBHV RGBS
RGsB,
RsGsBs,
Component
S-video
Composite
video
R
G
B
H
V
50/60 Hz
100-240V- 1.3A
LISTED
1T23
I.T.E. C U S
IN
P
U
T
O
U
T
P
U
T
S
IN3254 1 2 3 4
R
G
B
H
V
X1.3
S Y N C L
E V E L
V ID
E O G
A IN
X1
HI
LOW 1
2 3 4
5
Rear panel
Power LED
Power
connector
Video input Video outputs
Sync and gain
DIP switches
X1.3
S
Y
N
C
L
E
V
E
L
V
ID
E
O
G
A
IN
X1
HI
LOW
Apply gain for long cable runs, up to
200 feet (61 m) using Extron MHR cable
Do not add gain.
Select 5 V peak-to-peak
sync output
Select 3 V peak-to-peak
sync output